Are you looking for China door factory?

Where can I get an entry door side lite?

i am looking for a side lite panel only; i don’t need the door.it needs to be steel. it can be used. it will get painted.it is standard size,13×80,but i need an opening to accomodate a 12×48 glass window.I need to be able to pick up in or around indianapolis area.

Yeah here I give you some additional info:

ok, i guess i didn’t make myselg clear. i already have a new door and the framed glass for the sideof the door. what i need now is just the panel itself, with a window hole in it already, or able to cut a 4ft window hole in it without screwing up the pattern on the panel. see, i can use someones old pc and redo it. i guess fiberglass or steele would work.

Answer:

The task sounds somewhat ambitious. I`m also wondering about the numbers. If you`re looking for panel only, one would have to assume you have an exsisting side lite. Why not modify exsisting panel? If what you say is true(13X80 panel) you will quit probably have some installation issues. Unless you have more than 13 inches inside the jambs, the “window” will lap into the rabbits. There won`t be any room for finish trim. How thick is this “window”? Keep in mind the panel is probably an inch and three quarters thick. Also the glass height sounds little tall. If the panel has an embosed panel at the bottom, “window” may intrude on it. You may have to get what is called a flush panel. If I haven`t detered you from your task, check with local door distributors. They will most likely have what you seek. Yellow Pages.